RV Tips - Precision Sealants

Maintaining the seals and roof of your Recreational Vehicle (RV) is the single most critical task for preventing water damage. Proactive care prevents expensive repairs and preserves the structural integrity of your vehicle.

The Importance of Seals and Sealants

RVs are subject to constant expansion and contraction due to temperature shifts and road movement. This stress causes factory-applied sealants around windows, doors, vents, and seams to crack, shrink, or detach over time.

Sealant Selection Guide

Choosing the correct sealant is vital for an effective repair, as incompatible materials can cause premature seal failure.

Sealant Type	Common Use Cases	Key Feature
Self-Leveling	Horizontal roof seams (vents, antennas, skylights)	Flows to fill gaps; creates a level waterproof layer
Non-Sag (Lap)	Vertical seams, sidewall joints, windows, doors	Holds shape on vertical surfaces; excellent adhesion
Butyl Tape	Installing windows, vents, and trim	Compresses to form a watertight gasket; stays flexible
Silicone	Interior applications or specific exterior parts	Excellent UV resistance but difficult to re-seal

Roof Material Basics

Different roof materials require specific cleaning and maintenance approaches.

Rubber Roofs (EPDM and TPO)

• EPDM: A thick black rubber often covered with white-pigmented acrylic for UV protection.
• TPO: A lighter, white thermoplastic material that is generally more puncture-resistant than EPDM.
• Maintenance Tip: Use only cleaners designed specifically for your roof material; avoid petroleum-based products or abrasive cleaners which can cause damage.

Fiberglass and Aluminum Roofs

While these materials are more durable and require less frequent membrane maintenance, the perimeter and fixture seals remain critical inspection points.

The 90-Day Inspection Rule

Inspect all roof and sidewall seals every 90 days, or before and after long trips. Key areas to check include:

• All four sidewall-to-roof seams
• Skylights, vent covers, and air conditioner units
• Antennas (TV, satellite, radio)
• Clearance lights and running lights
• Access doors (water fill, refrigerator vents)
• Window and door perimeters

Professional Application Steps

1. Remove Old Sealant: Carefully scrape away loose or degraded sealant without damaging the roof membrane. Use a solvent like mineral spirits to remove residue.
2. Clean: Wash the area to remove dirt and oil; the surface must be perfectly dry before application.
3. Apply: Apply a uniform, continuous bead of the appropriate sealant, completely covering the old seal and filling all gaps.
4. Cure: Allow the sealant to fully cure according to manufacturer instructions before exposing the RV to rain or travel.